Set: On the operation interface, press the setting button to enter the setting interface and then press the setting button to move the setting content. After moving to the mold diameter, press the setting button again to return to the operation interface.

+: On the operation interface, press the “+” key to add the number.

-: On the operation interface, press the “-” key to reduce the number.

Stop: When the device is running, press the "Stop" key, the equipment will stop the motor operation, and open the pressure relief valve to release the pressure.

Demould: Press the "Demould" key, the device will start, when the pressure exceeds the specified pressure, or contact the limit switch, the device will automatically stop and pressure relief. You can also stop the operation manually.

Sample: Press the "Sample" key, the device will start, when the pressure reaches the set pressure, it will stop the pressure and start the pressure retention (this process will be timed), when the pressure is below the lower limit, it will automatically replenish the pressure, and finally reach the set time, it will automatically relieve the pressure.

Step 1: Select the data screen and enter the Settings screen

Step 2: Select the first and second temperature zones to control the temperature of the upper and lower heating plates.

Step 3: There are 20 temperature control procedures in the program, select the first paragraph.

Step 4: According to the requirements of the experiment, set the temperature and heating speed of the first stage.

Step 5: If you need multiple heating procedures, you can set up 20 procedures.

Step 6: After setting, press the main screen to return to the operation screen.