Pressure

·Max. 100 Metric Tons

·10 - 100 T adjustable by digital controller

·Pressure accuracy: +/- 1%

Electric Hydraulic Pump

·Standard: 110VAC - 240V AC ( single phase 。 50/60hz )  for worldwide use

·750 W  AC motor

·Optional: 110V-220V transformer for using under 110V

Bottom Hydraulic Cylinder Travel Distance

0 - 30 mm

Top Support Screw Adjustable Height

320 mm

Working Space 

·Top  & Bottom working plate::  300  mm x 250 mm

Protection Shield

·Thick plastic shields around the press with electric interlock

·Note: Must close door before operation

Net Weight

·500 Kg

Shipping Dimensions

48"(L) x 41"(W) x 42"(H)

Weight of Shipment

560 kg

Application Notes

·Check the Oil Level regularly using the included oil dipstick. Add AW 46 Hydraulic Oil if the Oil Level when low.

·The pressing die cannot be used for pressing powder with the particle size < 30 microns. Small particles may slip into the gap between pushing rod and steel sleeve and cause damages to the sleeve during the compression. Ball mill and sieve the powder and apply only the 32~75 microns power to the pressing die to avoid the damages. Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to separate the 32~75 microns particles from the powder clumps. Please clean the die via ethanol after the completion of each experiment.

·Do not raise the bottom cylinder (piston) more than it's maximum traveling distance. (50mm)

·Warning: Customers must always wear protection goggles during operation !!!

·For reasons of transportation or Idle for a long time, please tighten the nuts of the oil filling hole, which will affect pressurization.  

·Operate the presser inside the glove box is not recommended

Compliance

·CE Certified

Press Dies (optional)

Pressing dies with various diameters are available upon request at extra cost

Warranty

Two years limited warranty with lifetime support